|
IC Electronic Three phase controllers |
|
Tuesday, 10 May 2005 |
 IC Electronic Soft Starters Simple soft starter modules covering single phase control, two phase control and three phase control of induction motors. These modules are self contained including the heatsink, but do not include motor protection. Applications would ideally have a standard DOL or integral starter upstream.
|
|
Last Updated ( Thursday, 20 April 2006 )
|
|
Read more...
|
|
|
Tuesday, 26 April 2005 |
|
Emotron VFB/VFX is a range of high performing frequency inverters designed for controlling asynchronous motors over a wide speed and torque range. Typical applications include centrifuges, cranes, elevators, saws, winders and milling machines.
Full control with less equipment
The direct torque control gives you full speed and/or torque control without encoder feedback. When using VFB/VFX you eliminate the need for brake choppers and resistors that often are used in industrial applications. For e.g. cranes, you will have complete control of hoist and grab without external plc.
|
|
Last Updated ( Sunday, 13 April 2008 )
|
|
Read more...
|
|
|
Emotron MSF Soft Starters |
|
Sunday, 24 April 2005 |
|
30% lower starting current
The torque ramp uses in average 30% less current compared to other soft starters. This results in smaller fuses and lower energy costs.
Built-in Shaft Power Monitor
The built-in shaft power monitor protects your machines and processes from expensive break downs and production down time. The monitor typically prevents jammed conveyors, dry running pumps, worn-out tools etc. The Load Monitor has the same functions as our M20 Shaft Power Monitor. Pump Control
The built-in pump control is based on square torque ramps. This gives a linear speed change at start and stop without any tacho or encoder. It prevents water hammering and simpler valves and smaller pipes are other positive effects. Built in Braking Techniques
The MSF Softstarter brakes catches all types of load. It also
detects when the motor is standing still. Quick stops are managed for productivity and safety reasons. - Dynamic DC brake without contactor for medium loads.
- Controlled sensorless soft brake with reversing contactor for heavy loads.
|
|
Last Updated ( Sunday, 13 April 2008 )
|
|
Read more...
|
|
|
|
<< Start < Previous 1 2 3 4 5 Next > End >>
|
| Results 17 - 20 of 20 |
